New version of iRelay+ firmware (6.6.3)
The new iRelay + firmware upgrade enables a new service for sending data – MQTT
With this service comes new great possibilities of using iRelay. Currently, this upgrade is only available on the plus version
Register for Firmware updates
Dear friends, due to increasing problems with some people, we have decided to limit the content of the website www.nautilis.eu to unregistered users.
You can register via the link: https://www.nautilis.eu/log-in/
and access to limited parts of the website will be possible after approval by the administrator.
Everyone who has purchased and is using one of the Nautilis devices will receive administrator approval.
The currently restricted content is the firmware upgrade page.
Important note! In the Description field, write which device you are using and where you purchased the device.
Thank you for understanding.
New version of iRelay firmware (6.5.8)
The old Blynk legacy app has been removed and support for the new Blynk IOT app has been added.
Nautilis Oled thermometer firmware upgrade (6.2.1), (6.2.2), (6.2.3) and (6.2.4)
In the new updates, a new Blynk IOT application has been added and the WiFi connection has been improved.
Nautilis thermometer Firmware upgrade (6.1.5), (6.1.6), (6.1.7) & New version of iRelay firmware (6.5.7)
iRelay changes are related to improved usage on iOS devices. The option to change the SSID and password has been added on all versions of the thermometer. High and low temperature alarm for SHT version, interval to send every 60 minutes & support for SENSOR SPY application is novelty.
Nautilis thermometer Firmware upgrade (6.1.4) & New version of iRelay firmware (6.5.6)
Only system changes have been made to the iRelay classic firmware. iRelay Light now has the ability to DIY & make and convert to a temperature controller. In the management menu it is possible to switch on / off a special relay switch for heating and a special relay switch for cooling. To upgrade to a controller you need a relay module like this one. The default state is off. Only system changes were made on the thermometer. Firmware site
Nautilis thermometer Firmware upgrade (6.1.3)
The new upgrade allows you to convert a classic OLED thermometer into a WiFi temperature controller like the V4. In particular, you can control the heating and cooling relay. The initial state of these relays is switched off. To upgrade to a controller you need a relay module like this one.
