New version of iRelay firmware (6.5.8)

The old Blynk legacy app has been removed and support for the new Blynk IOT app has been added.

Nautilis Oled thermometer firmware upgrade (6.2.1), (6.2.2), (6.2.3) and (6.2.4)

In the new updates, a new Blynk IOT application has been added and the WiFi connection has been improved.

Nautilis Oled thermometer firmware upgrade (6.2.0)

Due to the incompatibility of the new BLYNK application and the high price of a new subscription to Blynk services, Nautilis devices will no longer support Blynk. Blynk Legacy will be removed from all devices in future firmware updates. MQTT support was added instead. 

Nautilis thermometer Firmware upgrade (6.1.5), (6.1.6), (6.1.7) & New version of iRelay firmware (6.5.7)

iRelay changes are related to improved usage on iOS devices. The option to change the SSID and password has been added on all versions of the thermometer. High and low temperature alarm for SHT version,  interval to send every 60 minutes & support for SENSOR SPY application is novelty.

Nautilis thermometer Firmware upgrade (6.1.4) & New version of iRelay firmware (6.5.6)

Only system changes have been made to the iRelay classic firmware. iRelay Light now has the ability to DIY & make and convert to a temperature controller. In the management menu it is possible to switch on / off a special relay switch for heating and a special relay switch for cooling. To upgrade to a controller you need a relay module like this one. The default state is off. Only system changes were made on the thermometer. Firmware site

Nautilis thermometer Firmware upgrade (6.1.3)

The new upgrade allows you to convert a classic OLED thermometer into a WiFi temperature controller like the V4. In particular, you can control the heating and cooling relay. The initial state of these relays is switched off. To upgrade to a controller you need a relay module like this one.

Nautilis thermometer Firmware upgrade (6.1.1 & 6.1.2)

In version 6.1.1, the ability to connect SHT sensors for temperature and humidity has been added. Possibilities still need to be considered for this option. In version 6.1.2, the ability to send data to Ubidots has been added. Firmware for both versions of the thermometer can be downloaded here.

Thermometer data is here.

New version of iRelay firmware (6.5.5)

The new firmware version allows iRelay thermometer data to be sent to the UbiDots application independent of iSpindel data. Firmware site

Did you know?

Did you know that every Nautilis WiFi thermometer can be iRelay? How? Just upgrade the firmware and a miracle will happen 🙂 The only thing is that the thermometer, because it does not have an external antenna, will have a weaker signal and will not have the power to receive data from stainless steel fermenters. But if you don’t have a problem with that this is quite a handy option. Of course, the possibility of switching from iRelay to a thermometer is also valid.

New color on offer

Due to frequent inquiries about the white color of the device housing, white devices are also available from today. When querying, it is necessary to specify the color immediately, since the standard color is black.